Integrated Circuits - ICs

ZXTR2105FQ is a 60V input, 5V 15mA regulator transistor.

A high-voltage linear regulator transistor with 100V input, 12V output, and 30mA current in SOT23F package.

The ZXRE160 is a 5-terminal adjustable shunt regulator offering excellent temperature stability and output handling capability.

The ZXRE160 is a 5-terminal adjustable shunt regulator offering excellent temperature stability and output handling capability.

The ZXMS6006DT8 is a dual self protected low side MOSFET with logic level input.

The ZXLD1371 is an LED driver controller IC for driving external MOSFETs to drive high current LEDs. It is a multi-topology controller enabling it to efficiently control the current through series connected LEDs.

ZXGD3105N8 synchronous controller is designed for driving a MOSFET as an ideal rectifier to replace a diode for increasing power transfer efficiency.

The ZXGD3104 is intended to drive MOSFETs configured as ideal diode replacements. The device is comprised of a differential amplifier detector stage and high current driver.

The ZXGD3006E6 is a 40V Gate Driver for switching IGBTs and SiC MOSFETs. It can transfer up to 10A peak source/sink current into the gate for effective charging and discharging of a large capacitive load.

A high-speed non-inverting single MOSFET gate driver capable of driving up to 9A into a MOSFET or IGBT gate capacitive load from supply voltages up to 12V with typical propagation delay times down to 3ns and rise/fall times down to 11ns.

AUTOMOTIVE COMPLIANT MICROPOWER CURRENT MONITOR

Cost effective adjustable precision shunt regulator with excellent temperature stability and output current handling capability up to 100mA.

The ZRC330 is a precision 3.3V low knee current voltage reference using bandgap circuit design.

The ZLDO1117Q is a low-dropout positive adjustable or fixed-mode regulator with 1A output current capability.

1A low dropout positive regulator with 1.2V, 1.5V, 1.8V, 2.5V, 3.3V, 5.0V and adjustable outputs.

ZDS1009 current mirror for high side current sense and level translation applications.

The ZABG6003 is an advanced GaAs and HEMT FETs bias controller designed to operate from minimal supply rails and intended primarily for satellite Low Noise Blocks (LNBs).

The WT325 TCXO series is a high performance temperature compensated oscillator with a clipped sinewave output for a very low operating supply current.

The TLV431 is a three-terminal, adjustable shunt regulator offering excellent temperature stability and output current handling capability up to 20mA.

CMOS RAIL TO RAIL OUTPUT OPERATIONAL AMPLIFIERS with 2.7V minimum supply voltage.

CMOS RAIL TO RAIL OUTPUT OPERATIONAL AMPLIFIERS

The TLV27x provides a higher performance alternative to the TLC27x series of op-amps with rail-to-rail output swing and low supply current.

3.3V HCSL Low Jitter PCIe® 2.0 Crystal Clock Oscillator (XO).

The SN Series 3.3V crystal clock oscillator achieves superb jitter and stability over a broad range of operating conditions and frequencies.

A 7.0x5.0 mm seam sealed crystal clock oscillator with a nominal frequency of 100.000000 MHz.

The PT8A2767x is a mixed signal CMOS LSI chip designed as a simple power switch circuit for shaver, toothbrush and other electrical devices.

The PT7M78xx family microprocessor (μP) supervisory circuits are targeted to improve reliability and accuracy of power-supply circuitry in μP systems.

Real-time Clock Module (I2C Bus)

PT7A7511-15/7521-25/7531-35 μP Supervisor Circuits

The PI90LV211/PI90LVT211 is a 1:6 differential clock distribution chip designed for low-skew, high-speed clocking applications using LVDS technology.

PI7C9X7952 is a PCI Express Dual UART device.

I2C-Bus/SPI to UART Bridge Controller with 64 bytes of TX/RX FIFOs

PI7C9X754 is a high-performance 1.62V to 3.6V quad UART with 64-byte FIFO.

PI7C9X111SL PCI Express-to-PCI Reversible Bridge

Asynchronous 2-Port PCI-to-PCI Bridge

Asynchronous 2-Port PCI-to-PCI Bridge

2-port PCI-to-PCI bridge

PI6ULS5V9511A is a hot-swappable I2C-bus and SMBus buffer that allows I/O card insertion into a live board backplane without corrupting the data and clock buses.

Level Translating I2C-Bus/SMBus Repeater with Tiny Package

Single output LVPECL clock generator optimized for Ethernet reference clock frequencies.

A 2-output LVDS synthesizer optimized to generate Ethernet reference clock frequencies.

The DIODES PI6CG33801C is an 8-output very low power PCIe Gen1/Gen2/Gen3/Gen4/Gen5/Gen6 clock generator with on-chip termination.

The DIODES PI6CG33202C is a 2-output very low power PCIe Gen1/Gen2/Gen3/Gen4/Gen5/Gen6 clock generator.

The DIODES PI6CG330440 is a 19-output very low jitter clock generator.

The PI6CFGL401B is a 4-output very low power clock generator for PCIe Gen1-2-3 applications with integrated output terminations providing Zo=100Ω.

PI6CDBL401B is a 4-output low power buffer for 100MHz PCIe Gen1, Gen2 and Gen3 applications with integrated output terminations providing Zo=100Ω.

The DIODES PI6CBE33125 is a low-power PCIe® 1.0/2.0/3.0/4.0/5.0/6.0 clock buffer.

Very-Low-Power 8-Output PCIe Clock Buffer with On-Chip Termination

Very-Low-Power 8-Output PCIe Clock Buffer with On-Chip Termination

Very-Low-Power 8-Output PCIe Clock Buffer with On-Chip Termination