Tools & Supplies

The LTC®4011 provides a complete, cost-effective nickel battery fast charge solution in a small package using few external components.

USB-based controller with SPI and I2C ports for Linear Technology QuikEval demo boards.

Standalone Linear Li-Ion Battery Charger with Thermal Regulation in ThinSOT

LTC4284 negative voltage hot swap controller with energy monitor.

The LTC7804 is a high performance synchronous boost DC/DC switching regulator controller that drives an all N-channel power MOSFET stage.

A high performance step-down switching regulator DC/DC controller that drives an all N-channel synchronous power MOSFET stage with phase-lockable frequency up to 2.25MHz.

High Speed Rail-to-Rail Input Comparator with LVDS Compatible Outputs

Dual 25A or Single 50A DC/DC µModule Regulator with 1% DC Accuracy

The LTC4279 is an autonomous single port power sourcing equipment (PSE) controller designed for use in IEEE 802.3at Type 1, Type 2 and LTPoE++ compliant Power over Ethernet (PoE) systems.

The LTC®4091 is a 36V Li-Ion battery charger and power backup manager.

Fast 150V Protected High Side NMOS Static Switch Driver

Fast high side N-channel MOSFET gate driver that operates from input voltages up to 135V.

LTC2984 Multi-Sensor High Accuracy Digital Temperature Measurement System with EEPROM

The LTM8003 is a 40V, 6A peak, 3.5A continuous step-down Silent Switcher µModule regulator.

The LTC4013 is a high voltage battery charger that is well suited for charging a wide range of lead-acid batteries including both vented and sealed types.

The LTC3789 is a high performance buck-boost switching regulator controller that operates from input voltages above, below or equal to the output voltage.

The LT®3752/LT3752-1 are current mode PWM controllers optimized for an active clamp forward converter topology.

The LTC®4015 is a complete synchronous buck controller/charger with pin-selectable, chemistry specific charging and termination algorithms.

The LT3840 is a high voltage synchronous step-down regulator controller capable of operating from a 2.5V to 60V supply.

The LTC6804 is a 3rd generation multicell battery stack monitor that measures up to 12 series connected battery cells with a total measurement error of less than 1.2mV.

The LTM®8024 is 40V, dual 3.5A or single 7A step-down Silent Switcher µModule regulator.

60V, 3A, 2MHz Step-Down Switching Regulator with 2.7µA Quiescent Current

LTC3789 is a high performance buck-boost switch regulator controller that operates from input voltages above, below or equal to the output voltage.

The LTC4098-3.6 is a high efficiency USB PowerPath controller and full-featured LiFePO battery charger.

The LTM8062/LTM8062A are complete 32V, 2A µModule power tracking battery chargers.

The LTC4070 allows simple charging of Li-Ion/Polymer batteries from very low current, intermittent or continuous charging sources.

The LTC3789 is a high performance buck-boost switch regulator controller that operates from input voltages above, below or equal to the output voltage.

100W Isolated Forward Converter with Synchronous Rectification

The LTM8023 is a complete 2A, DC/DC step-down power supply.

Dual, Multiphase Step-Down Voltage Mode DC/DC Controller with Current Sharing

LT1511 current mode PWM battery charger for fast charging Li-Ion, NiMH, and NiCd batteries with constant-current and constant-voltage modes.

The ADPA7005 is a gallium arsenide (GaAs), pseudomorphic high electron mobility transfer (pHEMT), monolithic microwave integrated circuit (MMIC), 32 dBm saturated output power (P_SAT), >1 W, power amplifier, with an integrated temperature compensated, on-chip power detector that operates between 18 GHz and 44 GHz.