MAX322CSA+ [Analog Devices]

MAX322CSA+ Overview

The electrical component comes in 8-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around 0°C~70°C TA extended. In total, 8 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 5V, it should be turned on and run. Into the electrical component body are injected 8 pins. On the other hand, analog switches can be constructed using SPST - NO/NC switching circuits. Circuits number 2 make up this analogue multiplexer. Look for analog switch ic variants by searching with MAX322. A 35Ohm internal resistance characterizes this multiplexer. The datasheets for the 8 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 8V. A analog switch ic that has a cost-effective Dual supply type. It is recommended to use 2.7V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 1?A current. A voltage higher than 200?A may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 8VFor dual power supplies, a voltage of at least 2.7V should be attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer.

MAX322CSA+ Features

1 Channels
Switch Circuit: SPST - NO/NC
1?A Supply Current

MAX322CSA+ Applications

There are a lot of Maxim Integrated
MAX322CSA+ Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)