MAX332CPE [Analog Devices]

MAX332CPE Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-DIP (0.300, 7.62mm). In order to provide high reliability, an advanced packaging method Tube is used. There is an analog multiplexer mounted in position Through Hole. There is 1:1 ratio between the number of multiplexers and demultiplexers. Around 0°C~70°C TA is the extended operating temperature. In total, there are 16 terminations. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. The analog switch ics are built using SPST - NO switching circuits. A total of 4 circuits make up this switch device. Search with MAX332 if you are looking for analog multiplexer variants. It has an internal resistance of 175Ohm. The functions of 16 pins can be found in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 20V volts for the multiplexer. Dual supply type digital switch with a low cost. 4.5V is the lowest voltage that should be fed to the electronic electronic part. A digital multiplexer may suffer damage if voltage is applied above 100?A. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 18V. In the case of dual power supplies, you should connect at least 4.5V. There are SEPARATE OUTPUT outputs on this analog switch ic.

MAX332CPE Features

Switch Circuit: SPST - NO

MAX332CPE Applications

There are a lot of Maxim Integrated
MAX332CPE Analog Switches & Multiplexers ICs applications.

• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems