MAX767CAP+ [Analog Devices]

MAX767CAP+ Overview

In the 20-SSOP (0.209, 5.30mm Width) package, the switching controller meets most application requirements. There is sufficient capacity to generate switching controller for outputs 1. There is a Tube solid enclosure around the pmic. With this function, you can deal with Transistor Driver dc switching's outputs (s). DC control operates at 4.5V~5.5V volts and has 4.5V~5.5V supply voltage. Suitable for working in an dc switcher that has a 0°C~70°C TA. It can switch at 200kHz 300kHz. As it has a Surface Mount value, it can be used for general dc dc regulator. To provide efficient switching control, Enable, Soft Start is included in the dcdc regulator. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. DUAL are the position of the terminal of the switching converters. Various 20 terminations. This dc dc converter ic uses a variety of control techniques, including PULSE WIDTH MODULATION. There is a DC switcher's nominal voltage of 5V. In addition to "MAX767", there are other relevant dc to dc converter ics you can find. There are 20 pins on switching converter. Specifically, switching converter falls under the Switching Regulator or Controllers category. DC regulator outputs 3.3V voltage based on test statistics. A starting point for a project is to note down the dc dc regulator's usual output current, which is 10A. Because of DC switcher's Surface Mount, it is suitable for most prototype designs and applications. A frequency of 300kHz is set for the switching controller. In order for the voltage regulator dc to dc to perform safely and reliably in a circuit, users are advised to apply 5.5V. Since the dc switcher's maximum input voltage is 5.5V, the voltage must be regulated accordingly. Voltage 4.5V must be supplied. An output current greater than 1A cannot be provided by the dc switcher. Depending on the datasheet, the switching converter can output 3.3V volts at its peak. A voltage controller's lowest output voltage cannot be less than 3.6V.

MAX767CAP+ Features

Transistor Driver Outputs
Switching Frequency: 200kHz 300kHz
Enable, Soft Start
PULSE WIDTH MODULATION
Frequency: 300kHz

MAX767CAP+ Applications

There are a lot of Maxim Integrated
MAX767CAP+ DC to DC converter applications.

• Network technology
• Automation technology
• CMM
• Various precision measuring instruments
• Various precision measuring detectors
• Flaw detection equipment
• Balance equipment
• Industrial robots
• Industrial controllers
• Die casting equipment