FT200XD [FTDI]

FT200XD – Full Speed USB to I2C Bridge in 10 pin DFN package

This USB2.0 Full Speed IC offers a compact bridge to I2C devices. The device is an I2C slave, capable of operating up to 3.4MBit/s, with low power consumption (8mA). The FT200XD includes the complete FT-X series feature set and enables USB to be added into a system design quickly and easily over an I2C interface.

Key Hardware Features

• Single chip USB to I2C interface.
• Entire USB protocol handled on the chip. No USB specific firmware programming required.
• Fully integrated 2048 byte Multi-Time-Programmable (MTP) memory for storing device descriptors and CBUS I/O configuration.
• Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
• 512 byte receive buffer and 512 byte transmit buffer utilizing buffer smoothing technology to allow for high data throughput.
• FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
• Configurable CBUS I/O pin.
• Battery Charger detection. May be used by mobile devices to detect the presence of a charger on the USB port for higher current / faster charging of batteries.
• Device supplied pre-programmed with unique USB serial number.
• Supports bus powered, self powered and high-power bus powered USB configurations.
• Integrated +3.3V level converter for USB I/O.
• True 3.3V CMOS drive output and TTL input.
  • (Operates down to 1.8V with external pull ups and is also 5V tolerant)
• Configurable I/O pin output drive strength.
• Integrated power-on-reset circuit.
• Internal 3.3V/1.8V LDO regulators
• Low operating current of 8mA (typical) and USB suspend current of 125uA (typical) current.
• Low USB bandwidth consumption.
• UHCI/OHCI/EHCI host controller compatible.
• USB 2.0 Full Speed compatible.
• Extended operating temperature range: -40°C to 85°C.
• Compact Pb-free 10 Pin DFN package (RoHS compliant