74ABT16374CSSCX [Onsemi]

74ABT16374CSSCX Overview

The flip flop is packaged in 48-BSSOP (0.295, 7.50mm Width). Package Tape & Reel (TR)embeds it. As configured, the output uses Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electrical part that is mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74ABTseries contain this type of chip. It should not exceed 150MHzin its output frequency. In total, there are 2 elements. There is a consumption of 2mAof quiescent energy. The 74ABT16374family includes it. This JK flip flop has a 5pFfarad input capacitance. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 48pins on it. This device has Positive Edgeas its clock edge trigger type. An electronic part designed with 16bits is used in this application. Its superior flexibility is attributed to its use of 8 circuits. If high efficiency is desired, the supply voltage should be kept at 5V. With a current output of 64mA , it offers maximum design flexibility. It has 3 output lines to operate. As of now, there are 2input lines. -32mA is set as the high level output current. In the low level output current setting, 64mAis used. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 150MHz frequencies.

74ABT16374CSSCX Features

Tape & Reel (TR) package
74ABT series
48 pins
16 Bits

74ABT16374CSSCX Applications

There are a lot of ON Semiconductor
74ABT16374CSSCX Flip Flops applications.

• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers