74AC273PC [Onsemi]

74AC273PC Overview

It is embeded in 20-DIP (0.300, 7.62mm) case. A package named Tubeincludes it. T flip flop uses Non-Invertedas the output. The trigger configured with it uses Positive Edge. It is mounted in the way of Through Hole. The JK flip flop operates at 2V~6Vvolts. In this case, the operating temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. In this case, it is a type of FPGA belonging to the 74AC series. You should not exceed 175MHzin the output frequency of the device. During its operation, it consumes 40μA quiescent energy. D latch belongs to the 74AC273 family. Its input capacitance is 4.5pFfarads. Through Hole mounts this electronic component. This board has 20 pins. There are 8bits in this flip flop. Due to its superior flexibility, it uses 8 circuits. As a result of its output current of 24mA, it is very flexible in terms of design. It operates with 8 output lines. Currently, there are 3 input lines present. -24mAis the output current at high level. It is set to 24mAfor low level output current. Operating temperatures should be lower than 85°C. It is recommended that the operating temperature is higher than -40°C. The system operates with a minimum supply voltage of 2V. 6Vis its maximum supply voltage. It is possible to obtain a frequency of 175MHz. In its basic building block, there are 8 gates. A total of 1inputs are used.

74AC273PC Features

Tube package
74AC series
20 pins
8 Bits
8 gates

74AC273PC Applications

There are a lot of ON Semiconductor
74AC273PC Flip Flops applications.

• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors