74ACT377PC [Onsemi]

74ACT377PC Overview

It is embeded in 20-DIP (0.300, 7.62mm) case. A package named Tubeincludes it. T flip flop uses Non-Invertedas the output. The trigger configured with it uses Positive Edge. It is mounted in the way of Through Hole. The JK flip flop operates at 4.5V~5.5Vvolts. In this case, the operating temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. In this case, it is a type of FPGA belonging to the 74ACT series. You should not exceed 175MHzin the output frequency of the device. The list contains 1 elements. During its operation, it consumes 40?A quiescent energy. D latch belongs to the 74ACT377 family. Its input capacitance is 4.5pFfarads. Through Hole mounts this electronic component. This board has 20 pins. It has a clock edge trigger type of Positive Edge. There are 8bits in this flip flop. Due to its superior flexibility, it uses 8 circuits. High efficiency requires the supply voltage to be maintained at 5V. It operates with 8 output lines. Currently, there are 8 input lines present. -24mAis the output current at high level. It is set to 24mAfor low level output current. Operating temperatures should be lower than 85°C. It is recommended that the operating temperature is higher than -40°C. The system operates with a minimum supply voltage of 4.5V. 5.5Vis its maximum supply voltage. It is possible to obtain a frequency of 175MHz.

74ACT377PC Features

Tube package
74ACT series
20 pins
8 Bits

74ACT377PC Applications

There are a lot of ON Semiconductor
74ACT377PC Flip Flops applications.

• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors