74F174SC [Onsemi]

74F174SC Overview

It is embeded in 16-SOIC (0.154, 3.90mm Width) case. A package named Tubeincludes it. T flip flop uses Non-Invertedas the output. The trigger configured with it uses Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. In this case, the operating temperature is 0°C~70°C TA. This logic flip flop is classified as type D-Type. In this case, it is a type of FPGA belonging to the 74F series. You should not exceed 80MHzin the output frequency of the device. The list contains 1 elements. During its operation, it consumes 45mA quiescent energy. D latch belongs to the 74F174 family. Surface Mount mounts this electronic component. This board has 16 pins. It has a clock edge trigger type of Positive Edge. There are 6bits in this flip flop. Due to its superior flexibility, it uses 7 circuits. High efficiency requires the supply voltage to be maintained at 5V. It operates with 3 output lines. Currently, there are 6 input lines present. -1mAis the output current at high level. It is set to 20mAfor low level output current. Operating temperatures should be lower than 70°C. It is recommended that the operating temperature is higher than 0°C. The system operates with a minimum supply voltage of 4.5V. 5.5Vis its maximum supply voltage. It is possible to obtain a frequency of 80MHz.

74F174SC Features

Tube package
74F series
16 pins
6 Bits

74F174SC Applications

There are a lot of ON Semiconductor
74F174SC Flip Flops applications.

• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors