74F374PC [Onsemi]

74F374PC Overview

It is embeded in 20-DIP (0.300, 7.62mm) case. A package named Tubeincludes it. T flip flop uses Tri-State, Non-Invertedas the output. The trigger configured with it uses Positive Edge. It is mounted in the way of Through Hole. The JK flip flop operates at 4.5V~5.5Vvolts. In this case, the operating temperature is 0°C~70°C TA. This logic flip flop is classified as type D-Type. In this case, it is a type of FPGA belonging to the 74F series. You should not exceed 140MHzin the output frequency of the device. The list contains 1 elements. During its operation, it consumes 86mA quiescent energy. D latch belongs to the 74F374 family. Through Hole mounts this electronic component. This board has 20 pins. It has a clock edge trigger type of Positive Edge. There are 8bits in this flip flop. Due to its superior flexibility, it uses 8 circuits. High efficiency requires the supply voltage to be maintained at 5V. It operates with 3 output lines. Currently, there are 8 input lines present. -3mAis the output current at high level. It is set to 24mAfor low level output current. Operating temperatures should be lower than 70°C. It is recommended that the operating temperature is higher than 0°C. The system operates with a minimum supply voltage of 4.5V. 5.5Vis its maximum supply voltage. It is possible to obtain a frequency of 140MHz.

74F374PC Features

Tube package
74F series
20 pins
8 Bits

74F374PC Applications

There are a lot of ON Semiconductor
74F374PC Flip Flops applications.

• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors