74F74PC [Onsemi]

74F74PC Overview

As a result, it is packaged as 14-DIP (0.300, 7.62mm). The package Tubecontains it. Currently, the output is configured to use Differential. It is configured with a trigger that uses Positive Edge. The electronic part is mounted in the way of Through Hole. A voltage of 4.5V~5.5Vis used as the supply voltage. 0°C~70°C TAis the operating temperature. This D latch has the type D-Type. It belongs to the 74Fseries of FPGAs. There should be no greater frequency than 125MHzon its output. There are 2 elements in it. As a result, it consumes 16mA of quiescent current without being affected by external factors. This D latch belongs to the family of 74F74. In this case, the electronic component is mounted in the way of Through Hole. The electronic flip flop is designed with pins 14. Its clock edge trigger type is Positive Edge. The flip flop is designed with 2bits. The superior flexibility of this product is achieved by using 2 circuits. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. Its output current of 20mAallows for maximum design flexibility. It is designed with 2 output lines. It is reported that there are 4 input lines. High level output current is set to -1mA. Low level output current is set to 20mA. A temperature below 70°Cshould be used for operation. Ideally, the operating temperature should be greater than 0°C. The minimal supply voltage is 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. It is possible to achieve a frequency of 125MHz. In its basic form, it contains 2 gates.

74F74PC Features

Tube package
74F series
14 pins
2 Bits
2 gates

74F74PC Applications

There are a lot of ON Semiconductor
74F74PC Flip Flops applications.

• Computers
• Communications
• Counters
• Frequency Dividers
• Shift Registers
• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch