74AC374TTR Overview

The flip flop is packaged in 20-TSSOP (0.173, 4.40mm Width). Package Tape & Reel (TR)embeds it. As configured, the output uses Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electrical part that is mounted in the way of Surface Mount. With a supply voltage of 2V~6V volts, it operates. It is operating at -55°C~125°C TA. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74ACseries contain this type of chip. It should not exceed 270MHzin its output frequency. In total, there are 1 elements. There is a consumption of 4?Aof quiescent energy. Currently, there are 20 terminations. The 74AC374family includes it. The D flip flop is powered by a voltage of 3.3V . This JK flip flop has a 4pFfarad input capacitance. Devices in the ACfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 8bits is used in this application. As soon as 6Vis reached, Vsup reaches its maximum value. A normal operating voltage (Vsup) should remain above 2V. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. It runs on 3.3/5Vvolts of power. A D flip flop with 2embedded ports is available. It has 8 output lines to operate.

74AC374TTR Features

Tape & Reel (TR) package
74AC series
20 pins
8 Bits
3.3/5V power supplies

74AC374TTR Applications

There are a lot of STMicroelectronics
74AC374TTR Flip Flops applications.

• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers