M74HC374B1R [STMicroelectronics]

M74HC374B1R Overview

The flip flop is packaged in a case of 20-DIP (0.300, 7.62mm). You can find it in the Tubepackage. It is configured with Tri-State, Non-Invertedas an output. It is configured with a trigger that uses a value of Positive Edge. Through Holemounts this electrical part. A voltage of 2V~6Vis required for its operation. Temperature is set to -55°C~125°C TA. It belongs to the type D-Typeof flip flops. In FPGA terms, D flip flop is a type of 74HCseries FPGA. Its output frequency should not exceed 90MHz Hz. D latch consists of 1 elements. As a result, it consumes 4?A quiescent current. Terminations are 20. Members of the M74HC374family make up this object. The power source is powered by 4.5V. A JK flip flop with a 5pFfarad input capacitance is used here. Electronic devices of this type belong to the HC/UHfamily. Electronic part Through Holeis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. The design is based on 8bits. Vsup reaches 6V, the maximal supply voltage. Keeping the supply voltage (Vsup) above 2V is necessary for normal operation. Its flexibility is enhanced by 8 circuits. The D latch runs on a voltage of 2/6V volts. The D flip flop has no ports embedded. It offers maximum design flexibility with its output current of 7.8mA. To operate, the chip has a total of 3 output lines.

M74HC374B1R Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

M74HC374B1R Applications

There are a lot of STMicroelectronics
M74HC374B1R Flip Flops applications.

• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers
• Asynchronous counter