TL032IDRE4 [Texas Instruments]

TL032IDRE4 Overview

Packaged in a D case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Tape and Reel case. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 570?V for this buffer op amp. As long as the supply current of the chip does not exceed 434?A, this op amp ic can operate. 82.61dB should remain the voltage gain. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 85°C should be used. The linear amplifier consists of 2 different elements in total. The operating supply voltage of the buffer op amp is rated at 15V. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 15V volts.

TL032IDRE4 Features

8 Pins
supply voltage of 5V
82.61dB voltage gain

TL032IDRE4 Applications

There are a lot of Texas Instruments
TL032IDRE4 Instrumentational OP Amps applications.

• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement
• Power control
• Information processing
• Weak signal detection