Name: DG333ADJ
Brand: Vishay
SKU: DG333ADJ

Type

Parameter

Factory Lead Time

8 Weeks

Mounting Type

Through Hole

Package / Case

20-DIP (0.300, 7.62mm)

Surface Mount

Number of Pins

Weight

2.508989g

Operating Temperature

-40°C~85°C TA

Packaging

Tube

Published

2008

JESD-609 Code

Pbfree Code

Part Status

Obsolete

Moisture Sensitivity Level (MSL)

1 (Unlimited)

Number of Terminations

Resistance

45Ohm

Terminal Finish

Tin/Lead (Sn/Pb)

Max Power Dissipation

890mW

Technology

CMOS

Number of Functions

Output

SEPARATE OUTPUT

Pin Count

Number of Channels

Number of Circuits

Max Supply Voltage

40V

Min Supply Voltage

Turn On Delay Time

175 ns

Voltage - Supply, Single/Dual (±)

5V~40V ±4V~22V

Supply Type

Dual, Single

Turn-Off Delay Time

145 ns

Max Dual Supply Voltage

22V

On-State Resistance (Max)

45Ohm

Min Dual Supply Voltage

Multiplexer/Demultiplexer Circuit

2:1

Current - Leakage (IS(off)) (Max)

250pA

Channel Capacitance (CS(off), CD(off))

8pF

Switch Circuit

SPDT

Switch Time (Ton, Toff) (Max)

175ns, 145ns

Charge Injection

10pC

Crosstalk

-80dB @ 1MHz

Switching

BREAK-BEFORE-MAKE

Drain to Source Resistance

45Ohm

Height

3.81mm

Length

26.92mm

Width

7.11mm

REACH SVHC

Unknown

Radiation Hardening

RoHS Status

RoHS Compliant

DG333ADJ Overview

This electronic part is conveniently packaged in 20-DIP (0.300, 7.62mm), making it easy to ship abroad. This high-reliability packaging method uses advanced packaging methods Tube. A switch device like this is mounted in Through Hole. 2:1 is the ratio of multiplexer to demultiplexer circuits. An extended operating temperature of -40°C~85°C TA degrees Celsius. In total, there have been 20 terminations. A 4 channel electronic part produces high-quality output. An injection of 20 pins is performed into the body of the electrical component. Unlike digital switches, these are based on SPDT switching circuits. 1 circuits are used in this analogue multiplexer. Analog switches have 45Ohm internal resistance. To find out what the 20 pins do, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. Users should never supply a voltage higher than 40V to a switch device. Analog switch ics with Dual, Single supply type are cost-effective. There should be 5V voltage fed to the electrical part below 5V. The switch multiplexer may be damaged if it is exposed to voltage greater than 200?A. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 22V. The voltage should be at least 4V if you are using dual power supplies. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. Resistivity from Drain to Source is 45Ohm for this electronic part.