Integrated Circuits - ICs

The TS117 integrated circuit device combines a 350V normally open (1-Form-A) relay with an optocoupler in a single package.

The TS117L integrated circuit device combines a current-limiting, 350V, normally open (1-Form-A) relay and an optocoupler in a single package.

The LIA100 and LIA101 are linear isolation amplifiers that integrate a linear optocoupler with two op amps in a single package. They are available in a 16 Pin SOIC or DIP package.

The LIA100 and LIA101 are linear isolation amplifiers that integrate a linear optocoupler with two op amps in a single package.

Linear isolation amplifiers that integrate a linear optocoupler with two op amps in a single package. Available in 16 Pin SOIC or DIP package.

The LDS9003 is a 3-channel and LDS9001 is a 1-channel LED junction temperature monitor and control device intended for use in high power LED solid state lighting applications.

The LDS8869 is a high efficiency multi-mode fractional charge pump with ultra low dropout voltage that can drive up to six LEDs.

The LDS8868 is a high efficiency multi-mode fractional charge pump with ultra low dropout voltage that can drive up to six LEDs.

The LDS8866 is a high efficiency multi-mode fractional charge pump with ultra low dropout voltage that can drive up to six LEDs.

The LDS8865 is a high efficiency multi-mode fractional charge pump with ultra low feedback voltage that can drive up to six LEDs. The ultra low dropout PowerLite Current Regulator increases device’s efficiency up to 94%.

LDS8845 is a high efficiency ultra-low dropout current regulator that can drive up to four LEDs.

The LDS8726 is a fixed frequency current mode boost converter with internal synchronous rectifier and cycle-by-cycle switch current limit specifically designed to drive matrix of LEDs in respect with the Table 1.

The LDS8724 is a fixed frequency current mode boost converter with internal synchronous rectifier and cycle-by-cycle switch current limit specifically designed to drive matrix of LEDs.

LDS8720 is a fixed frequency current mode boost converter with internal synchronous rectifier and cycle-by-cycle switch current limit specifically designed to drive matrix of LEDs.

The LDS8711 is a fixed frequency current mode boost converter with internal rectifier and cycle-by-cycle switch current limit specifically designed to drive a string of up to 10 White LEDs.

The LDS8681 is a high efficiency regulated charge pump with low dropout voltage that can drive two LEDs at up to 800 mA total.

LDS8680 is a high efficiency charge pump with low dropout voltage that can drive two LEDs at 400 mA each simultaneously or one LED at 800 mA per channel.

The LDS8621 is a high efficiency multi-mode fractional charge pump with ultra low feedback voltage that can drive up to two high-current LEDs.

The LDS8620 is a high efficiency multi-mode fractional charge pump with ultra low feedback PowerLite™ Current Regulator.

6-Channel (LDS8161) and 4-Channel (LDS8141) high-side linear WLED driver with LED temperature compensation, I2C, and digital PWM.

LDS8160 is a dual-output RGB or 6-channel white LED driver with three temperature compensation circuits for each bank of two LED drivers.

6-Channel / 4-Channel High-Side Linear WLED Driver with LED Temperature Compensation Using LED-SenseTM, I2C, and Digital PWM

The IXS839/IXS839A/IXS839B are 2A Source / 4A Sink Synchronous Buck MOSFET Drivers.

The IXS839/IXS839A/IXS839B are 2A Source / 4A Sink Synchronous Buck MOSFET Drivers designed to drive two N-channel power MOSFETs in a synchronous buck converter.

2A Source / 4A Sink Synchronous Buck MOSFET Drivers designed to drive two N-channel power MOSFETs in a synchronous buck converter.

2A Source / 4A Sink Synchronous Buck MOSFET Drivers designed to drive two N-channel power MOSFETs in a synchronous buck converter.

The IXS839/IXS839A/IXS839B are 2A Source / 4A Sink Synchronous Buck MOSFET Drivers. These Synchronous Buck MOSFET Drivers are specifically designed to drive two N-channel power MOSFETs in a synchronous buck converter.

The IXS839/IXS839A/IXS839B are 2A Source / 4A Sink Synchronous Buck MOSFET Drivers. These Synchronous Buck MOSFET Drivers are specifically designed to drive two N-channel power MOSFETs in a synchronous buck converter.

The IXRFD631 is a CMOS high-speed, high-current gate driver specifically designed to drive MOSFETs in Class D and E HF RF applications as well as other applications requiring ultrafast rise and fall times or short minimum pulse widths.

The IXRFD631 is a CMOS high-speed, high-current gate driver specifically designed to drive MOSFETs in Class D and E HF RF applications as well as other applications requiring ultrafast rise and fall times or short minimum pulse widths.

The IXRFD615 is a CMOS high-speed, high-current gate driver specifically designed to drive MOSFETs in Class D and E HF RF applications as well as other applications requiring ultrafast rise and fall times or short minimum pulse widths.

The IXI858 and IXI859 combine a power MOSFET driver, linear voltage regulator, and charge pump regulator for power supply generation in a single SOIC-8 package.

Gate Driver with VReg and Charge Pump Regulator in SOIC-8 package

The IXI858 and IXI859 combine a power MOSFET driver, linear voltage regulator, and charge pump regulator for power supply generation in a single SOIC-8 package.

The IXI858 and IXI859 combine a power MOSFET driver, linear voltage regulator, and charge pump regulator for power supply generation in a single SOIC-8 package.

2A single low-side ultrafast MOSFET drivers for driving IXYS MOSFETs and IGBTs.

High speed high current gate drivers designed to drive MOSFETs and IGBTs to their minimum switching time and maximum practical frequency limits.

The IXDR502 and IXDS502 each consist of a single 2A CMOS high speed gate driver for driving the latest IXYS MOSFETs & IGBTs.

This 5 V HCMOS integrated circuit is intended primarily for application in three-phase, sinusoidally commutated brushless motor, induction motor, AC servomotor or UPS PWM modulator control systems.

This 5 V HCMOS integrated circuit is intended primarily for application in three-phase, sinusoidally commutated brushless motor, induction motor, AC servomotor or UPS PWM modulator control systems. It injects the required deadtime to convert a single phase leg PWM command into the two separate logic signals required to drive the upper and lower semiconductor switches in a PWM inverter.

The IXDP610 is a programmable CMOS digital pulse width modulator (DPWM) that accepts digital pulse width data from a microprocessor and generates two complementary, non-overlapping PWM signals for direct control of switching power bridges.

14-Ampere Low-Side Ultrafast MOSFET Drivers. High-speed gate drivers for driving IXYS MOSFETs and IGBTs with 14A peak source/sink current and less than 30ns rise/fall times.

14-Ampere Low-Side Ultrafast MOSFET Drivers for driving IXYS MOSFETs and IGBTs.

9-Ampere Low-Side Ultrafast MOSFET Drivers

The IXD_602 series are dual low-side ultrafast MOSFET drivers with 2A peak source/sink drive current, designed for driving MOSFETs and IGBTs in high-frequency and high-power applications.

The IXDF602/IXDI602/IXDN602 dual high-speed gate drivers are especially well suited for driving the latest IXYS MOSFETs and IGBTs.

The IXDI514 and IXDN514 are high speed high current gate drivers specifically designed to drive the largest IXYS MOSFETs & IGBTs to their minimum switching time and maximum practical frequency limits.

The IXDI514 and IXDN514 are high speed high current gate drivers specifically designed to drive the largest IXYS MOSFETs & IGBTs to their minimum switching time and maximum practical frequency limits.

The IXDI514 and IXDN514 are high speed high current gate drivers specifically designed to drive the largest IXYS MOSFETs & IGBTs to their minimum switching time and maximum practical frequency limits.

The IXDI514 and IXDN514 are high speed high current gate drivers specifically designed to drive the largest IXYS MOSFETs & IGBTs to their minimum switching time and maximum practical frequency limits.