MAX4622CPE [Analog Devices]

MAX4622CPE Overview

The electrical component comes in 16-DIP (0.300, 7.62mm) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Through Hole, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around 0°C~70°C TA extended. In total, 16 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. Into the electrical component body are injected 16 pins. On the other hand, analog switches can be constructed using SPDT switching circuits. Circuits number 2 make up this analogue multiplexer. Look for analog switch ic variants by searching with MAX4622. A 5Ohm internal resistance characterizes this multiplexer. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 4.5V as the lowest voltage for the electrical part. A voltage higher than 500nA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 20VFor dual power supplies, a voltage of at least 4.5V should be attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. This electrical part is compatible with 20V operating voltages.

MAX4622CPE Features

1 Channels
Switch Circuit: SPDT

MAX4622CPE Applications

There are a lot of Maxim Integrated
MAX4622CPE Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)