74ACT174SC [Onsemi]

74ACT174SC Overview

The flip flop is packaged in 16-SOIC (0.154, 3.90mm Width). Package Tubeembeds it. As configured, the output uses Non-Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electrical part that is mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74ACTseries contain this type of chip. It should not exceed 200MHzin its output frequency. In total, there are 1 elements. There is a consumption of 40?Aof quiescent energy. The 74ACT174family includes it. This JK flip flop has a 4.5pFfarad input capacitance. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 16pins on it. This device has Positive Edgeas its clock edge trigger type. An electronic part designed with 6bits is used in this application. Its superior flexibility is attributed to its use of 7 circuits. If high efficiency is desired, the supply voltage should be kept at 5V. With a current output of 24mA , it offers maximum design flexibility. It has 6 output lines to operate. As of now, there are 3input lines. -24mA is set as the high level output current. In the low level output current setting, 24mAis used. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 100MHz frequencies.

74ACT174SC Features

Tube package
74ACT series
16 pins
6 Bits

74ACT174SC Applications

There are a lot of ON Semiconductor
74ACT174SC Flip Flops applications.

• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers