74ACT273MTC [Onsemi]

74ACT273MTC Overview

It is packaged in the way of 20-TSSOP (0.173, 4.40mm Width). D flip flop is embedded in the Tube package. The output it is configured with uses Non-Inverted. The trigger it is configured with uses Positive Edge. This electronic part is mounted in the way of Surface Mount. It operates with a supply voltage of 4.5V~5.5V. The operating temperature is -40°C~85°C TA. The type of this D latch is D-Type. It is a type of FPGA belonging to the 74ACT series. Its output frequency should not exceed 189MHz. D latch consists of 1 elements. It consumes 40?A of quiescent current without being affected by external factors. JK flip flop belongs to 74ACT273 family. The input capacitance of this T flip flop is 4.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. This electronic part is mounted in the way of Surface Mount. It is designed with 20 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This flip flop is designed with 8 Bits. 8 circuits are used to achieve its superior flexibility. The supply voltage should be maintained at 5V for high efficiency. There are 8 output Lines, which generate the binary equivalent of the input line whose value is equal to ?1? and are available to encode either a decimal or hexadecimal input pattern to typically a binary or ?B. C. D? (binary coded decimal) output code. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. The high level output current is set to -24mA. The low level output current is set to 24mA. The operating temperature should be lower than 85°C. The operating temperature should be higher than -40°C. It operates with the minimal supply voltage of 4.5V. It supports the maximal supply voltage of 5.5V. The frequency that can be achieved is 189MHz.

74ACT273MTC Features

Tube package
74ACT series
20 pins
8 Bits

74ACT273MTC Applications

There are a lot of ON Semiconductor
74ACT273MTC Flip Flops applications.

• Digital electronics systems
• Computers
• Communications
• Counters
• Frequency Dividers
• Shift Registers
• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer