74ACT534SCX [Onsemi]

74ACT534SCX Overview

The package is in the form of 20-SOIC (0.295, 7.50mm Width). As part of the package Tape & Reel (TR), it is embedded. In the configuration, Tri-State, Invertedis used as the output. This trigger uses the value Positive Edge. Surface Mountis positioned in the way of this electronic part. The JK flip flop operates at a voltage of 4.5V~5.5V. It is at -40°C~85°C TAdegrees Celsius that the system is operating. There is D-Type type of electronic flip flop associated with this device. In terms of FPGAs, it belongs to the 74ACT series. In order for it to function properly, its output frequency should not exceed 100MHz. The element count is 1 . It consumes 40?A of quiescent The 74ACT534 family contains this object. A 4.5pFfarad input capacitance is provided by this T flip flop. It is mounted in the way of Surface Mount. There are 20pins on it. The clock edge trigger type for this device is Positive Edge. An electronic part with 8bits has been designed. In order to achieve its superior flexibility, 8 circuits are used. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. There are no output lines on the JK flip flop. 8input lines are available for you to choose from. A high level output current of -24mAis set. In the low level output current setting, the current is set to 24mA. Ideally, the operating temperature should be below 85°C. If the operating temperature is higher than -40°C, the system should operate properly. In order for it to operate, a supply voltage of 4.5Vis required. A maximum voltage of 5.5V can be provided by it. This frequency can be achieved at 100MHz.

74ACT534SCX Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits

74ACT534SCX Applications

There are a lot of ON Semiconductor
74ACT534SCX Flip Flops applications.

• Frequency Dividers
• Shift Registers
• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division