74ACT821MTCX [Onsemi]

74ACT821MTCX Overview

As a result, it is packaged as 24-TSSOP (0.173, 4.40mm Width). The package Tape & Reel (TR)contains it. Currently, the output is configured to use Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. The electronic part is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. -40°C~85°C TAis the operating temperature. This D latch has the type D-Type. It belongs to the 74ACTseries of FPGAs. There should be no greater frequency than 150MHzon its output. There are 1 elements in it. As a result, it consumes 80?A of quiescent current without being affected by external factors. This D latch belongs to the family of 74ACT821. Its input capacitance is 4.5pF farads. In this case, the electronic component is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 24. Its clock edge trigger type is Positive Edge. The flip flop is designed with 10bits. The superior flexibility of this product is achieved by using 10 circuits. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. It is designed with 3 output lines. It is reported that there are 10 input lines. High level output current is set to -24mA. Low level output current is set to 24mA. A temperature below 85°Cshould be used for operation. Ideally, the operating temperature should be greater than -40°C. The minimal supply voltage is 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. It is possible to achieve a frequency of 150MHz.

74ACT821MTCX Features

Tape & Reel (TR) package
74ACT series
24 pins
10 Bits

74ACT821MTCX Applications

There are a lot of ON Semiconductor
74ACT821MTCX Flip Flops applications.

• Computers
• Communications
• Counters
• Frequency Dividers
• Shift Registers
• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch