74F374SJ [Onsemi]

74F374SJ Overview

The flip flop is packaged in a case of 20-SOIC (0.209, 5.30mm Width). You can find it in the Tubepackage. It is configured with Tri-State, Non-Invertedas an output. It is configured with a trigger that uses a value of Positive Edge. Surface Mountmounts this electrical part. A voltage of 4.5V~5.5Vis required for its operation. Temperature is set to 0°C~70°C TA. It belongs to the type D-Typeof flip flops. In FPGA terms, D flip flop is a type of 74Fseries FPGA. Its output frequency should not exceed 140MHz Hz. D latch consists of 1 elements. As a result, it consumes 86mA quiescent current. Members of the 74F374family make up this object. Electronic part Surface Mountis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. The design is based on 8bits. Its flexibility is enhanced by 8 circuits. In order to ensure high efficiency, the supply voltage should remain at 5V. To operate, the chip has a total of 3 output lines. This input has 8lines in it. It is set to -3mAfor the high level output current. It is set to 24mAfor the low level output current. If the operating temperature is lower than 70°C, it is recommended. It should be higher than 0°Cwhen the system is operating. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. It supports a maximum supply voltage of 5.5V volts. This frequency can be achieved 140MHz.

74F374SJ Features

Tube package
74F series
20 pins
8 Bits

74F374SJ Applications

There are a lot of ON Semiconductor
74F374SJ Flip Flops applications.

• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers
• Asynchronous counter