74F377SJ [Onsemi]

74F377SJ Overview

In the form of 20-SOIC (0.209, 5.30mm Width), it has been packaged. There is an embedded version in the package Tube. T flip flop uses Non-Invertedas its output configuration. Positive Edgeis the trigger it is configured with. Surface Mountis occupied by this electronic component. A supply voltage of 4.5V~5.5V is required for operation. A temperature of 0°C~70°C TAis considered to be the operating temperature. This electronic flip flop is of type D-Type. The FPGA belongs to the 74F series. A frequency of 130MHzshould be the maximum output frequency. A total of 1elements are contained within it. As a result, it consumes 48mA quiescent current and is not affected by external forces. It is a member of the 74F377 family. There is an electronic component mounted in the way of Surface Mount. 20pins are included in its design. This device's clock edge trigger type is Positive Edge. It is designed with a number of bits of 8. Using 1 circuits, it is highly flexible. In order to achieve high efficiency, the supply voltage should be maintained at 5V. The JK flip flop is with 3 output lines to operate. The number of input lines is 8. In this case, the high level output current is set to -1mA. 20mAis set as the low level output current. There should be a temperature below 70°Cduring operation. In order for the system to operate properly, the temperature should be higher than 0°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. There is a maximum voltage support of 5.5V. A frequency of 130MHzcan be achieved.

74F377SJ Features

Tube package
74F series
20 pins
8 Bits

74F377SJ Applications

There are a lot of ON Semiconductor
74F377SJ Flip Flops applications.

• Counters
• Frequency Dividers
• Shift Registers
• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory