BU4551BF-E2 [ROHM]

BU4551BF-E2 Overview

As the electronic part is packed in 16-SOIC (0.173, 4.40mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 2 channels. Powered by a 5V voltage supply, the electrical part should be switched on and run. The electrical component body receives 16 pins. Circuits based on SPDT switching are used to construct these analog switch ics. There are 4 circuits in this switch device. Try searching with BU4551B to find analog multiplexer variants. An switch multiplexer with 280Ohm internal resistance has a value of 280Ohm. Datasheets for 16 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 16V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 3V. An operating current of 15?A would be sufficient for this switch device. Using a single voltage supply, this switch device consumes 3V~16V volts. Despite this switch device's dual supply capability, its voltage should not exceed 8V. It is recommended that you attach at least 1.5V to your dual power supply. An analog IC with the number DIFFERENTIAL MULTIPLEXER is integrated into this board. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. There are 15MHz bandwidths for data transfer.

BU4551BF-E2 Features

2 Channels
Switch Circuit: SPDT
15?A Supply Current
Bandwidth: 15MHz

BU4551BF-E2 Applications

There are a lot of ROHM Semiconductor
BU4551BF-E2 Analog Switches & Multiplexers ICs applications.

• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement