74LCX374MTR [STMicroelectronics]

74LCX374MTR Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). You can find it in the Cut Tape (CT)package. It is configured with Tri-State, Non-Invertedas an output. It is configured with a trigger that uses a value of Positive Edge. Surface Mountmounts this electrical part. A voltage of 2V~3.6Vis required for its operation. Temperature is set to -55°C~125°C TA. It belongs to the type D-Typeof flip flops. In FPGA terms, D flip flop is a type of 74LCXseries FPGA. Its output frequency should not exceed 140MHz Hz. D latch consists of 1 elements. Terminations are 20. Members of the 74LCX374family make up this object. The power source is powered by 2.7V. A JK flip flop with a 6pFfarad input capacitance is used here. Electronic devices of this type belong to the LVC/LCX/Zfamily. Electronic part Surface Mountis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. The design is based on 8bits. Keeping the supply voltage (Vsup) above 2V is necessary for normal operation. Its flexibility is enhanced by 8 circuits. Due to its reliability, this T flip flop is well suited for TAPE AND REEL. The D flip flop has no ports embedded. To operate, the chip has a total of 3 output lines. This D latch consumes 10?A quiescent current at all.

74LCX374MTR Features

Cut Tape (CT) package
74LCX series
20 pins
8 Bits

74LCX374MTR Applications

There are a lot of STMicroelectronics
74LCX374MTR Flip Flops applications.

• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers
• Asynchronous counter