M74HC4066RM13TR [STMicroelectronics]

M74HC4066RM13TR Overview

The electrical component comes in 14-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -55°C~125°C TA extended. In total, 14 terminations have occurred. A electrical component with 4 channels is capable of high-quality output. When the electronic component is given a voltage of 4.5V, it should be turned on and run. Into the electrical component body are injected 14 pins. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Look for analog switch ic variants by searching with M74HC406. A 80Ohm internal resistance characterizes this multiplexer. The datasheets for the 14 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 12V. A analog switch ic that has a cost-effective Single supply type. It is recommended to use 2V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 8?A current. Analogue multiplexers require a 2V~12V voltage to drain from a single voltage supply. A voltage higher than 8?A may cause damage to the switch multiplexer. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. It is possible to transfer data over a 200MHz-bandwidth. There is 170Ohm Drain to Source resistance on this electronic part.

M74HC4066RM13TR Features

4 Channels
Switch Circuit: SPST - NO
8?A Supply Current
Bandwidth: 200MHz
Drain-to-Source resistance: 170Ohm

M74HC4066RM13TR Applications

There are a lot of STMicroelectronics
M74HC4066RM13TR Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)