M74HCT374B1R [STMicroelectronics]

M74HCT374B1R Overview

The flip flop is packaged in 20-DIP (0.300, 7.62mm). Package Tubeembeds it. As configured, the output uses Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electrical part that is mounted in the way of Through Hole. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at -55°C~125°C TA. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74HCTseries contain this type of chip. It should not exceed 50MHzin its output frequency. In total, there are 1 elements. There is a consumption of 4?Aof quiescent energy. Currently, there are 20 terminations. The 74HCT374family includes it. The D flip flop is powered by a voltage of 5V . This JK flip flop has a 5pFfarad input capacitance. Devices in the HCTfamily are electronic devices. A part of the electronic system is mounted in the way of Through Hole. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 8bits is used in this application. Its superior flexibility is attributed to its use of 8 circuits. It runs on 5Vvolts of power. A D flip flop with 2embedded ports is available. If high efficiency is desired, the supply voltage should be kept at 5V. It has 3 output lines to operate.

M74HCT374B1R Features

Tube package
74HCT series
20 pins
8 Bits
5V power supplies

M74HCT374B1R Applications

There are a lot of STMicroelectronics
M74HCT374B1R Flip Flops applications.

• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers