TS904IDT [STMicroelectronics]

TS904IDT Overview

In the package, you will find a SO-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Tape & Reel case is used for delivering the op amp. During the past two weeks, there have been close to 16 terminations. A total of 16 pins are located on this board. This linear amplifier should be powered by an 3V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 16 pins on it. You should keep the voltage gain at 89.54dB for the time being. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. This electric component can work from a voltage of under 16V as far as supply voltage is concerned. A voltage of 2.7V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 8V volts when you conduct this part.

TS904IDT Features

16 Pins
supply voltage of 3V
89.54dB voltage gain

TS904IDT Applications

There are a lot of STMicroelectronics
TS904IDT Instrumentational OP Amps applications.

• Multiplication circuits
• Division circuits
• Precision measurement
• Power control
• Information processing
• Weak signal detection
• Signal amplification
• Signal filtering
• Signal operation
• Video computer boards