Name: CD4052BNSRG4
Brand: Texas Instruments
SKU: CD4052BNSRG4

Type

Parameter

Contact Plating

Gold

Mount

Surface Mount

Package / Case

SOP

Number of Pins

Weight

200.686274mg

Packaging

Tape and Reel

JESD-609 Code

Moisture Sensitivity Level (MSL)

1 (Unlimited)

Number of Terminations

ECCN Code

EAR99

Resistance

240Ohm

Max Operating Temperature

125°C

Min Operating Temperature

-55°C

Technology

CMOS

Terminal Form

GULL WING

Peak Reflow Temperature (Cel)

260

Number of Functions

Supply Voltage

Output

SEPARATE OUTPUT

Pin Count

Operating Supply Voltage

18V

Power Supplies

5/15V

Temperature Grade

MILITARY

Number of Channels

Max Supply Voltage

20V

Min Supply Voltage

Analog IC - Other Type

DIFFERENTIAL MULTIPLEXER

Operating Supply Current

80nA

Number of Bits

Propagation Delay

20 ns

Turn On Delay Time

720 ns

Logic Function

Demultiplexer, Multiplexer

Number of Inputs

Supply Type

Dual, Single

Bandwidth

25MHz

Supply Current-Max (Isup)

0.6mA

Neg Supply Voltage-Nom (Vsup)

-5V

Turn-Off Delay Time

450 ns

Max Dual Supply Voltage

Min Dual Supply Voltage

2.5V

Off-state Isolation-Nom

40 dB

On-state Resistance Match-Nom

15Ohm

Switching

BREAK-BEFORE-MAKE

Normal Position

Signal Current-Max

0.01A

Radiation Hardening

RoHS Status

RoHS Compliant

Lead Free

CD4052BNSRG4 Overview

The electronic component is convenient to ship overseas because it is packed in a SOP. The advanced packaging method Tape and Reel provides high reliability. The total number of terminations is 16. As a result of its 2 channels, this electronic component provides high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. A total of 16 pins are injected into the body of the electronic part. The internal resistance of this digital multiplexer is 240Ohm. Datasheets for functions of 16 pins are available. Multiplexer or Switches is a typical switch device. normally, users should not supply switches with voltages higher than 20V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. A low voltage of 3V should be applied to the electronic component. This multiplexer would work with 80nA current. For this multiplexer, dual supply voltage is feasible, but it should not exceed 9V. A dual power supply should have at least 2.5V voltage attached. With a DIFFERENTIAL MULTIPLEXER analog IC integrated into the board. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. A voltage of 18V can be used to operate the electronic component. A 8 input needs to be operated. There are various bandwidths available for data transfer. It is not recommended to operate the switches in an environment with a temperature higher than 125°C. 4-bit conductivity is possible.