INA132P [Texas Instruments]

INA132P Overview

Packaged in a PDIP case, the buffer op amp is ready to use. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. A total of 8 pins are present on the instrumentation amplifier. As far as the device is concerned, buffer amplifier has 1 channels. Currently, linear amplifier is operating with a quiescent current of 160μA. It should be noted that the other type of analog integrated circuit used in this instrumentation amplifier is known as the ANALOG CIRCUIT. It is important to note that this buffer op amp also has the following extra benefit: IT CAN ALSO OPERATE WITH 2.7V TO 36V SINGLE SUPPLY.

INA132P Features

8 Pins
supply voltage of 15V

INA132P Applications

There are a lot of Texas Instruments
INA132P Instrumentational OP Amps applications.

• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement
• Power control
• Information processing
• Weak signal detection