Part No:
DG413DJ-E3
Category:
Switch ICs
Description:
175ns, 145ns SPST - NO/NC 35Ohm Analog Switches BREAK-BEFORE-MAKE DG413 16 Pins 250pA 15V 16-DIP (0.300, 7.62mm)
Package:
-
Production Status:
In Stock Status:
Specification
Moisture Sensitivity Level (MSL)
Peak Reflow Temperature (Cel)
Time@Peak Reflow Temperature-Max (s)
Voltage - Supply, Single/Dual (±)
Neg Supply Voltage-Nom (Vsup)
On-State Resistance (Max)
Multiplexer/Demultiplexer Circuit
Current - Leakage (IS(off)) (Max)
Channel Capacitance (CS(off), CD(off))
Switch Time (Ton, Toff) (Max)
Drain to Source Resistance
Products Detail
DG413DJ-E3 Overview
The electrical component comes in 16-DIP (0.300, 7.62mm) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Through Hole, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 16 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. Into the electrical component body are injected 16 pins. On the other hand, analog switches can be constructed using SPST - NO/NC switching circuits. Look for analog switch ic variants by searching with DG413. A 35Ohm internal resistance characterizes this multiplexer. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 13V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 1μA current. A voltage higher than 1μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 22VFor dual power supplies, a voltage of at least 7V should be attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. This electrical part is compatible with 15V operating voltages. Among the inputs that can be operated are the 4 inputs. There is 25Ohm Drain to Source resistance on this electronic part.
DG413DJ-E3 Features
1 Channels
Switch Circuit: SPST - NO/NC
1μA Supply Current
Drain-to-Source resistance: 25Ohm
DG413DJ-E3 Applications
There are a lot of Vishay Siliconix
DG413DJ-E3 Analog Switches & Multiplexers ICs applications.
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
- Data Acquisition Systems
- Relay Replacement
- Battery Powered Systems
- Existing multiplexer applications (both fault-protected and nonfault-protected)
Key Features
No key features available
Application scenarios
No application scenarios available
Documents
