Интегральные схемы - ИС

-

VT-803-EAE-2070-10M0000000

Vectron's VT-803 Temperature Compensated Crystal Oscillator (TCXO) is a quartz stabilized, clipped sine wave or CMOS output, 5th order analog temperature compensated oscillator, operating off a 2.8 to 5.0 volt supply in a hermetically sealed 3.2x5 mm ceramic package.

-

VS-705-ECE-KAAN-737M280000

Vectron's VT-803 Temperature Compensated Crystal Oscillator (TCXO) is a quartz stabilized, clipped sine wave or CMOS output, 5th order analog temperature compensated oscillator, operating off a 2.8 to 5.0 volt supply in a hermetically sealed 3.2x5 mm ceramic package.

-

The VSC8142, VSC8145 and VSC8147 are extended multi-rate transceivers with integrated Clock Recovery Unit (CRU) and Clock Multiplier Unit (CMU) for use in SONET/SDH, DWDM, and other optical transport systems.

-

The VSC8142, VSC8145 and VSC8147 are extended multi-rate transceivers with integrated Clock Recovery Unit (CRU) and Clock Multiplier Unit (CMU) for use in SONET/SDH, DWDM, and other optical transport systems.

-

Dual XAUI – Dual XGMII Octal 0.95 Gbps to 3.25 Gbps Transceiver

-

The VSC7216-02 is a quad channel parallel-to-serial and serial-to-parallel transceiver chip designed for use in high bandwidth data transmission between busses, backplanes and other subsystems.

-

Low Power Quad 1.25Gb/s Backplane Transceiver

-

VSC7216-02 Low Power Quad 1.25Gb/s Backplane Transceiver

-

The VSC3312 is a 12-port 6.5 Gbps asynchronous switch with advanced signal equalization designed for high-speed serial backplanes and cable interconnect applications.

-

The VSC3303 is a low-cost, low-power asynchronous crosspoint switch capable of data rates up to 8.5 Gbps.

-

4x4 and 8x8 crosspoint switches with integrated equalization for high-speed signals.

-

The VSC3104 is a 4x4 crosspoint switch with integrated equalization. The VSC3108 is a 8x8 crosspoint switch with integrated equalization.

-

VS-705-ECE-KAAN-491M520000

The VS-705 is a Voltage Controlled SAW Oscillator that operates at the fundamental frequency of the internal SAW filter.

-

The VS-705 is a Voltage Controlled SAW Oscillator that operates at the fundamental frequency of the internal SAW filter. The SAW filter is a high-Q Quartz device that enables the circuit to achieve low phase jitter performance over a wide operating temperature range.

-

VCSO (Voltage Controlled Sine-wave Oscillator) with 1968.75 MHz nominal frequency, ±20 ppm tuning range, and low jitter performance.

-

Vectron’s V-Type Voltage Controlled Crystal Oscillator (VCXO) is a quartz stabilized square wave generator with a CMOS output and is tested at CMOS and TTL (5.0 volt operation) logic levels.

-

VCS3 series 1.8, 2.5, 3.3 volt CMOS Oscillator

-

2.5 and 3.3 volt LVPECL Crystal Oscillator with low jitter performance.

-

VCC6 Crystal Oscillator (XO) is quartz stabilized square wave generator with a LVDS output, operating off a 2.5 or 3.3 volt supply.

-

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

-

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

-

VCC1 series is a family of CMOS oscillators operating at 1.8V, 2.5V, 3.3V, and 5.0V, offering frequencies up to 190 MHz with low jitter and tri-state output.

-

VCC1 series CMOS Oscillator with output frequencies up to 190 MHz, low jitter, and tri-state output.

-

VCC1 series CMOS Oscillator with output frequencies up to 190 MHz, low jitter, and tri-state output for board test and debug.

-

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

-

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

-

VCC1 series CMOS oscillator with output frequencies up to 190 MHz, low jitter, and tri-state output for board test and debug.

-

VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

-

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

-

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

VC-710-DFF-GFL-155M520

-

The VC-710 is a voltage controlled crystal oscillator that operates at the fundamental frequency of the internal HFF crystal. The HFF crystal is a high-Q quartz device that enables the circuit to achieve low phase jitter performance over a wide operating temperature range.

-

-40°C~85°C TA Настраиваемый PMIC TL431 1 канал 8-SOIC (0.154, 3.90 мм Ширина)

TC-140-BJF-106A-100M000

-