Инструменты разработки

SWIFTTM (TPS54xxx series) DC/DC Converter-based Power Management Solution providing 1.5A from 5V input for Xilinx FPGA applications.

XILINXPWR-082 EVM (HPA-082 board) is a power management solution for Xilinx FPGAs using TI's SWIFT DC/DC converters (TPS54xxx series) and LDOs, providing up to 6A from a 5V input.

TPS64203 Switching DC/DC Controller-Based Power Management Solution for Spartan™-3 Providing up to 3 A from V = 5.0 V or 3.3 V

The VCA2618 is a highly integrated, dual receive channel, Variable Gain Amplifier (VGA) with analog gain control.

The VCA2616 and VCA2611 are dual, low-noise preamplifiers plus low-noise variable gain amplifiers (VGA). The VCA2611 is an upgraded version of the VCA2616, differing only in input structure tolerance.

The UCD9112 is a synchronous buck digital PWM controller designed for point of load power applications. This device integrates dedicated circuitry for dc/dc loop management with a microcontroller core, flash memory and a PMBus™ interface.

The UCC39421 SEPIC demo board implements a complete 330-kHz, 3.3-V SEPIC converter.

The UCC39411/2/3 Evaluation Kit allows the designer to evaluate the performance of the UCC39411/2/3 Low power Synchronous Boost converter in a typical application circuit.

An isolated 10-W, 3.3-V flyback converter for telecom input voltages (-48 Vdc nominal, -32 to -75 Vdc range) using the UCC3809 primary-side controller and TLV431 shunt regulator.

The UCC3585 synchronous buck controller provides flexible high efficiency power conversion for output voltages as low as 0.9 V with ensured ±1% dc accuracy.

The UCC3580EVM is an evaluation board for flyback converters that allows comparison between active-clamp and hard-switched configurations using the UCC3580 PWM controller.

The UCC35705 voltage mode controller with voltage feed-forward provides the control of this telecom (36 V DC to 72 V DC) to 3.3-V converter with synchronous rectification. Capable of supplying 10 A of output current at 3.3 V with up to 85% efficiency, UCC35705EVM uses self-driven, high-speed, very low R_DS(on) MOSFETs for improved efficiency and high-speed operation.

The UCC29950EVM-631 evaluation module is a 300-W nominal, two-stage off-line converter. The EVM consists of a Continuous Conduction Mode (CCM) PFC input stage followed by a half-bridge LLC output and isolation stage.

The UCC28521 module is a 100-W offline ac-to-dc voltage converter with power factor correction (PFC).

300-W intermediate bus converter providing unregulated 9.6V output from 43-53V DC input, with telecom standard isolation between primary and secondary.

The UCC2540 is a voltage-mode secondary-side synchronous-buck PWM controller for high current and low output voltage applications.

UC385EVM-207 High-Current, Low-Input Voltage, Low-Dropout Linear Regulator evaluation module (EVM).

The TWL6032 is an integrated power-management IC (PMIC) for applications powered by a rechargeable battery, featuring five step-down converters and nine LDOs.

The TS3DDR32611 is a sink/source low power double data rate type III (PCDDR3) termination regulator with a 1% accuracy buffered reference output.

TRF6900 evaluation module (EVM) for mixed-signal RF products.

TRF4900 mixed-signal RF product evaluation module.

The TRF3702 is an ultralow-noise direct quadrature modulator that is capable of converting complex input signals from baseband or IF directly up to RF.

TRF3701/TRF3702 Quadrature Modulator

TRF1x22 evaluation module (EVM) is a transmit up-converter with integrated amplifiers and digital attenuator for WiMAX systems.

The TRF1216 is a 3.5-GHz high dynamic range low-noise down-converter IC that performs first down-conversion in 3.5-GHz radios, converting 3.3-3.8 GHz input to 400-500 MHz IF output.

The TRF1x22 is a transmit up-converter with integrated amplifiers and digital attenuator for use in a WiMAX system. This user’s guide provides an overview of the TRF1x22 evaluation module (EVM).

2.5-GHz, High Dynamic Range, Low-Noise Down-Converter that performs first down-conversion in MMDS/WCS radio 2300MHz to 2700MHz.

Evaluation modules for 2-A to 6-A integrated power solutions (IPS) devices.

150mA, wide VIN, low IQ, low-dropout regulator

TPS7A66xx EVM Evaluation Module helps designers evaluate the operation and performance of the TPS7A66xx linear regulator.

The TPS7A64xxEVM is an evaluation module designed to evaluate the operation and performance of the TPS7A64xx linear regulator.

The Texas Instruments TPS7A6050EVM evaluation module helps designers evaluate the operation and performance of the TPS7A6050-Q1 Low-Dropout Linear Regulator.

Texas Instruments TPS7A45xx low-noise fast-transient-response 1.5-A low-dropout (LDO) voltage regulator.

The TPS7A1601 is a low-dropout (LDO) linear regulator with internal thermal and current-limit shutdowns, enable, Power Good (PG) with user-programmable circuitry, in a DGN (MSOP-8) PowerPAD package, capable of delivering up to 100 mA.

The TPS7A10 is a low-dropout linear regulator (LDO) capable of delivering up to 300mA with ultra-low dropout voltage.

Evaluation Module for TPS799xx family of low quiescent current, ultra-low noise, high PSRR, low dropout linear regulators.

The TPS797xx family of low-dropout (LDO) regulators

Ultra-Low Noise, High-PSRR, Fast-RF, Low-Dropout Linear Regulators (LDOs) in 3.00 mm x 3.00 mm SON-8 packages

The TPS793 family of low-dropout (LDO) low-power linear voltage regulators features high power-supply rejection ratio (PSRR), ultralow-noise, fast start-up, and excellent line and load transient responses in NanoStar™ wafer chip scale and SOT23 packages.

The TPS78633EVM-207 is a 1.5-A high PSRR, low noise, low dropout linear regulator evaluation module (EVM).

User's guide for the TPS782xxEVM-445 evaluation module, demonstrating the TPS782xx low dropout linear regulator.

TPS782xxEVM-445 evaluation module for TPS782xx low dropout linear regulators with 150 mA output current in TSOT23-5 package.

Ultra low-power, low dropout (LDO) regulator with pin-selectable dual-output voltage levels.

Ultra Low-Power 100-mA Low-Dropout Linear Regulators

The TPS76901EVM-127, TPS76918EVM-127, and TPS76933EVM-127 LDO regulator modules provide cost-effective solutions for providing power to various low-voltage options.

The TPS746 is a low-dropout linear regulator (LDO) capable of delivering up to 1A with low dropout voltage, designed for high-speed communication systems.

The TPS735xxEVM-276 evaluation module (EVM) is designed to evaluate the operation and performance of the TPS735xx family of low dropout (LDO) linear regulators, which are capable of 500 mA output current at both fixed and adjustable output voltage levels.

The TPS735xxEVM-276 evaluation module (EVM) helps designers evaluate the operation and performance of the TPS735xx family. The TPS735xx is a 500-mA, low quiescent current, ultra-low noise, high PSRR, fast start-up LDO linear regulator.

200mA Low-Dropout Linear Regulator with Pin-Selectable Dual-Voltage Level Output

The TPS727xx is a 200mA, ultra-low Iq, fast transient response, linear regulator in a WCSP-4 package.