Integrated Circuits - ICs

The ZL50115/16/17/18/19/20 are CESoP processors for 32, 64, and 128 channels, providing circuit emulation over packet networks (MPLS, IP, Ethernet) with on-chip timing and synchronization recovery.

8 K Channel Digital Switch with High Jitter Tolerance, Single Rate (32 Mbps), and 16 Inputs and 16 Outputs

The ZL50017 is a maximum 1024 x 1024 channel non-blocking digital Time Division Multiplex (TDM) switch with sixteen input streams and sixteen output streams.

ZL50012 is a flexible 512-channel digital switch with non-blocking switching capability at multiple data rates and rate conversion between ST-BUS inputs and outputs.

The ZL490xx is a family of high performance DTMF receivers which decode all 16 tone pairs into a 4-bit binary code.

The ZL38065 Voice Echo Canceller implements a cost effective solution for telephony voice-band echo cancellation conforming to ITU-T G.168 requirements.

Vectron's VT-803 Temperature Compensated Crystal Oscillator (TCXO) is a quartz stabilized, clipped sine wave or CMOS output, 5th order analog temperature compensated oscillator, operating off a 2.8 to 5.0 volt supply in a hermetically sealed 3.2x5 mm ceramic package.

Vectron's VT-803 Temperature Compensated Crystal Oscillator (TCXO) is a quartz stabilized, clipped sine wave or CMOS output, 5th order analog temperature compensated oscillator, operating off a 2.8 to 5.0 volt supply in a hermetically sealed 3.2x5 mm ceramic package.

The VSC8142, VSC8145 and VSC8147 are extended multi-rate transceivers with integrated Clock Recovery Unit (CRU) and Clock Multiplier Unit (CMU) for use in SONET/SDH, DWDM, and other optical transport systems.

The VSC8142, VSC8145 and VSC8147 are extended multi-rate transceivers with integrated Clock Recovery Unit (CRU) and Clock Multiplier Unit (CMU) for use in SONET/SDH, DWDM, and other optical transport systems.

Dual XAUI – Dual XGMII Octal 0.95 Gbps to 3.25 Gbps Transceiver

The VSC7216-02 is a quad channel parallel-to-serial and serial-to-parallel transceiver chip designed for use in high bandwidth data transmission between busses, backplanes and other subsystems.

Low Power Quad 1.25Gb/s Backplane Transceiver

VSC7216-02 Low Power Quad 1.25Gb/s Backplane Transceiver

The VSC3312 is a 12-port 6.5 Gbps asynchronous switch with advanced signal equalization designed for high-speed serial backplanes and cable interconnect applications.

The VSC3303 is a low-cost, low-power asynchronous crosspoint switch capable of data rates up to 8.5 Gbps.

4x4 and 8x8 crosspoint switches with integrated equalization for high-speed signals.

The VSC3104 is a 4x4 crosspoint switch with integrated equalization. The VSC3108 is a 8x8 crosspoint switch with integrated equalization.

The VS-705 is a Voltage Controlled SAW Oscillator that operates at the fundamental frequency of the internal SAW filter.

The VS-705 is a Voltage Controlled SAW Oscillator that operates at the fundamental frequency of the internal SAW filter. The SAW filter is a high-Q Quartz device that enables the circuit to achieve low phase jitter performance over a wide operating temperature range.

VCSO (Voltage Controlled Sine-wave Oscillator) with 1968.75 MHz nominal frequency, ±20 ppm tuning range, and low jitter performance.

Vectron’s V-Type Voltage Controlled Crystal Oscillator (VCXO) is a quartz stabilized square wave generator with a CMOS output and is tested at CMOS and TTL (5.0 volt operation) logic levels.

VCS3 series 1.8, 2.5, 3.3 volt CMOS Oscillator

2.5 and 3.3 volt LVPECL Crystal Oscillator with low jitter performance.

VCC6 Crystal Oscillator (XO) is quartz stabilized square wave generator with a LVDS output, operating off a 2.5 or 3.3 volt supply.

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

VCC1 series is a family of CMOS oscillators operating at 1.8V, 2.5V, 3.3V, and 5.0V, offering frequencies up to 190 MHz with low jitter and tri-state output.

VCC1 series CMOS Oscillator with output frequencies up to 190 MHz, low jitter, and tri-state output.

VCC1 series CMOS Oscillator with output frequencies up to 190 MHz, low jitter, and tri-state output for board test and debug.

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

VCC1 series CMOS oscillator with output frequencies up to 190 MHz, low jitter, and tri-state output for board test and debug.

VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

Vectron’s VCC1 Crystal Oscillator (XO) is quartz stabilized square wave generator with a CMOS output, operating off a 1.8, 2.5, 3.3, or 5.0 volt supply.

The VC-710 is a voltage controlled crystal oscillator that operates at the fundamental frequency of the internal HFF crystal. The HFF crystal is a high-Q quartz device that enables the circuit to achieve low phase jitter performance over a wide operating temperature range.

Precision adjustable three terminal shunt voltage regulators, pin-to-pin compatible with industry standard TL431. Output voltage programmable from 2.5V to 36V with two external resistors.

The TC-140 series offers performance for short-term stability, phase noise, aging and temperature stability normally only associated with Oven Controlled Crystal Oscillators, while consuming typically <20 mA.

The SG140A/140 series of positive regulators offer self contained, fixed-voltage capability with up to 1.5A of load current and input voltage up to 50V (SG140A series only).

500mA Negative Adjustable Regulator

The SG137A family of negative adjustable regulators will deliver up to 1.5A output current over an output voltage range of -1.2V to -37V. Silicon General has made significant improvements in these regulators compared to previous devices, such as better line and load regulation, and a maximum output voltage error of 1%.

The SG137A family of negative adjustable regulators deliver up to 500mA output current over an output voltage range of -1.2 V to -37 V, with significant improvements in line and load regulation and a maximum output voltage error of 1%.

The radiation-tolerant (RT) ProASIC3 family of Microsemi flash FPGAs dramatically reduces dynamic power consumption by 40% and static power by 50%. These power savings are coupled with performance, density, true single chip, 1.2 V to 1.5 V core and I/O operation, reprogrammability, and advanced features.

PD64012GH is a twelve-port, mixed-signal, high-voltage High Power over Ethernet PSE Manager.

Microsemi provides very high frequency RF ICs and packaged modulator drivers for high speed/high frequency 100G+ optical transceivers for long haul, metro and datacenter applications.

NX7101 is a 340kHz fixed frequency, current mode, PWM synchronous buck (step-down) DC-DC converter, capable of driving a 2A load with high efficiency, excellent line and load regulation.

The NX4110 is a current mode PWM buck switcher with internal compensation, can provide up to 1A output current with FET on board.

The NX4108-33 is a current mode PWM buck switcher with internal compensation and fixed 3.3V output voltage, providing up to 1A output current with FET on board.

The MT93L00 Voice Echo Canceller implements a cost effective solution for telephony voice-band echo cancellation conforming to ITU-T G.168 requirements.