10 bit ADC, programmable sequencing, DDR VTT_REF, sleep modes, watchdog Timer. (4) 10A dual phase, Integrated FETs. Output voltage 0.3V – 1.9V (6) 16A quad phase, Integrated FETs. Output voltage 0.3V – 1.57V (1) 1x 15A triple phase + 1x 5A single phase, Integrated FETs. Output voltage 0.3V – 1.57V (4) 2 load switch controllers, 2 external LDO monitors (2) 20A peak dual phase, Integrated FETs. Output voltage 0.3V – 1. 9V (2) 20A quad phase, Integrated FETs. Output voltage 0.3V – 1.57V (4) 2x 10A dual phase, Integrated FETs. Output voltage 0.3V – 1.57V (5) 2x 8A dual phase, Integrated FETs. Output voltage 0.3V – 1.57V (1) 40A peak quad phase, Integrated FETs. Output voltage 0.3V – 1. 9V (2) 4A Load Switch (2) 6-channel H-bridge driver integrated on one chip- Motor for spindle, sled, focus, tracking, and loading can becontrolled with one chip- Drivers driving at 5 V and 10 V incorporated together- Logic block ca (1) 7 ch H-bridge motor driver with micro-step driving functionTwo stepper motors, two DC motors, and a coil can be driven simultaneously64-pin FLGA package, 5 mm (L) x 5 mm (W) x 0.91 mm (H), ideal for controlling lenses in (1) 8 Channel System PMIC supporting DDR VTT (3) 8 bit ADC (11) Dual 3A single phase, Integrated FETs. Output voltage 0.3V – 1. 9V (2) Dual 5A single phase, Integrated FETs. Output voltage 0.3V – 1.9V (6) Four H bridge circuits and low-side switch employing power MOSFETDirect PWM I/O systemHigh-speed PWM driving possible: Operating frequency up to 120 kHzEmploys 30-pin thin-type shrink SOP (0.65 mm pitch, 300 mils) (1) High-Performance Multi-Phase DC-DC Buck Converter (4) Incorporates 2 H-bridge outputs using power MOSFETs enabling two DCmotors to be driven Incorporates a brake function ideal for DC motor control.With the charge pump circuit and N ch configuration output stage, low-volta (1) Integrated MCU, Intel VR13 Compliant, Programmable Sequencing, Scalable output current (4) Low consumption current: IDD=100uA MAX.Small package: 16-pin SOP (7.62mm(300))High-speed PWM drive capability (1) Low on-resistance: Ron=0.6 ohms MAX.Low-voltage operation guaranteed, 3V driveStandby function which holds down power dissipation4-mode operation possible: forward/reverse/stop/brakeSpace-saving 16-pin plast (3) Low on-resistanceLow power dissipation4-input system for independent control of dual H bridge driver(1-2 phase excitation selected)For 12V/5V motor voltageInstalled in miniature surface mount pac (3) Low standby current (1) Low-voltage drive capabilitySupply voltage: 2.7V to 5.5VLow on-resistnaceLow power dissipationOn-chip power save function (2) N-channel high-side IPD, Hight temperature Tch = 175 deg.CLow on resistance (100 m ohm)Load short protection (Current control and thermal shutdown functions)Package: 8-pin SOPBuilt-in differential amplifier (gain = 8 times) (1) N-channel high-side IPD, Hight temperature Tch = 175 deg.CLow on resistance (100 m ohm)Load short protection (Current control and thermal shutdown functions)Package: 8-pin SOPSelf-testing function<br / (1) On-chip current control circuit and thermal shutdown circuitShutdown operation upon overheat detection and self-restoration after cool-downLow on resistance: RDS(ON) = 160 m ohm MAX.(output current: 0.8 A, Tch = 25 deg. (1) On-chip dynamic clamp circuit (100 V MIN.)
On-chip current control circuit and thermal shutdown circuit
Shutdown operation upon overheat detection and self-restoration after cool-down
Built-in disconnection-detection circuit
High temperature operation (Tch = 175°C Max.) (1) Programmable NVM for Power Up/Down Sequencing and Default Output Voltages, DDR VTT_REF, Sleep modes, Spread Spectrum, WatchDog Timer, RTC with Coin Cell Battery/SuperCap Charger (3) Programmable Sequencing (1) Programmable Sequencing, WatchDog Timer, RTC with Coin Cell Battery/SuperCap Charger (10) Protection circuit (Current Limiting, Overheating Protection)Dynamic clamp circuitOpen Load detection circuitSelf-diagnostics output circuit (1) RTC with coin cell/supercap charger, 10 bit ADC, programmable sequencing, DDR VTT_REF, sleep modes, Watchdog Timer (1) RTC with coin cell/supercap charger, 10 bit ADC, programmable sequencing, DDR VTT_REF, sleep modes, watchdog Timer. (6) Scalable output current, Automatic multi-phasing (2) Scalable output current, Coin Cell Charger, Analog to digital converter (ADC) (4) Scalable output current, Programmable Sequencing, Battery backup capacitor, Inrush current control (2) Scalable output current, Programmable Sequencing, Sleep modes including S0ix (1) Scalable output current, Sleep modes including S0ix, Programmable Sequencing (1) Scalable output current, Sleep modes, Programmable Sequencing (3) Spread Spectrum Clocking, Engine-off Timer, QA Watchdog Timer, 8 Voltage Monitors, Programmable Reset Generator (10) Ultra-low Iq Charger PMIC with 4-Output SIMO (1) o H bridge 1.5 circuit on chipo Upper/lower stage total on-resistance: Small 0.8 ohm max.o Operates on 2.5 V or above.o Small surface mount type package (2)