74ABT574CMSA [Onsemi]

74ABT574CMSA Overview

The flip flop is packaged in 20-SSOP (0.209, 5.30mm Width). Package Tubeembeds it. As configured, the output uses Tri-State, Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electrical part that is mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74ABTseries contain this type of chip. It should not exceed 200MHzin its output frequency. In total, there are 1 elements. There is a consumption of 50?Aof quiescent energy. The 74ABT574family includes it. This JK flip flop has a 5pFfarad input capacitance. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. An electronic part designed with 8bits is used in this application. Its superior flexibility is attributed to its use of 8 circuits. If high efficiency is desired, the supply voltage should be kept at 5V. It has 3 output lines to operate. As of now, there are 1input lines. -32mA is set as the high level output current. In the low level output current setting, 64mAis used. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 200MHz frequencies.

74ABT574CMSA Features

Tube package
74ABT series
20 pins
8 Bits

74ABT574CMSA Applications

There are a lot of ON Semiconductor
74ABT574CMSA Flip Flops applications.

• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers