M74HC76B1R [STMicroelectronics]

M74HC76B1R Overview

The flip flop is packaged in 16-DIP (0.300, 7.62mm). Package Tubeembeds it. As configured, the output uses Differential. In the configuration of the trigger, Negative Edgeis used. There is an electrical part that is mounted in the way of Through Hole. With a supply voltage of 2V~6V volts, it operates. It is operating at -55°C~125°C TA. Logic flip flops of this type are classified as JK Type. FPGAs belonging to the 74HCseries contain this type of chip. It should not exceed 67MHzin its output frequency. There is a consumption of 2?Aof quiescent energy. Currently, there are 16 terminations. The M74HC76family includes it. The D flip flop is powered by a voltage of 4.5V . This JK flip flop has a 5pFfarad input capacitance. Devices in the HC/UHfamily are electronic devices. A part of the electronic system is mounted in the way of Through Hole. This board is designed with 16pins on it. This device has Negative Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. As soon as 6Vis reached, Vsup reaches its maximum value. A normal operating voltage (Vsup) should remain above 2V. Its superior flexibility is attributed to its use of 2 circuits. Additionally, you may refer to the D latch's additional MASTER SLAVE OPERATION.

M74HC76B1R Features

Tube package
74HC series
16 pins

M74HC76B1R Applications

There are a lot of STMicroelectronics
M74HC76B1R Flip Flops applications.

• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers