STG5123DTR Overview

Shipping overseas is convenient with the electronic component packed in 6-UFDFN. High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 2:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 6. High-quality output is provided by the electronic component's 1 channels. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. The electronic part body is injected with 6 pins. A SPDT switching circuit is used to build these analog multiplexers. Try searching with STG5123 if you're looking for variants. There is 1.2Ohm internal resistance in this digital multiplexer. For functions related to 6 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 4.5V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. 1.65V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 50nA current would be sufficient. This analog switch requires a voltage of 1.65V~4.5V to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 100nA. It is possible to operate 1 inputs. The analogue multiplexer has 2 outputs.

STG5123DTR Features

1 Channels
Switch Circuit: SPDT
50nA Supply Current
-3db Bandwidth: 150MHz

STG5123DTR Applications

There are a lot of STMicroelectronics
STG5123DTR Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems