VND5HV100AJTR-E [STMicroelectronics]

The VND5HV100AJ-E is a monolithic device made using STMicroelectronics VIPower technology, intended for driving resistive or inductive loads with one side connected to the ground. Active VCC pin voltage clamp protects the device against low energy spikes.

The device integrates an analog current sense, which delivers a current proportional to the load current.

Fault conditions such as overload, overtemperature, or short to VCC are reported via the current sense pin.

Output current limitation protects the device in overload conditions. The device latches off in case of overload or thermal shutdown.

The device is reset by a low level pass on the fault reset standby pin.

A permanent low level on the inputs and on the fault reset standby pins disables all outputs and sets the device in standby mode.

• AEC-Q100 qualified
• General
  • Very low standby current
  • 3.0 V CMOS compatible input
  • Optimized electromagnetic emission
  • Very low electromagnetic susceptibility
  • Compliant with European directive 2002/95/EC
  • Fault reset standby pin (FR_Stby)
• Diagnostic functions
  • Proportional load current sense
  • High current sense precision for wide range currents
  • Off-state open-load detection
  • Output short to V_CC detection
  • Overload and short to ground latch-off
  • Thermal shutdown latch-off
  • Very low current sense leakage
• Protections
  • Undervoltage shutdown
  • Overvoltage clamp
  • Load current limitation
  • Self limiting of fast thermal transients
  • Protection against loss of ground and loss of V_CC
  • Thermal shutdown
  • Electrostatic discharge protection