Part No:
DG444BDY
Category:
Switch ICs
Description:
300ns, 200ns SPST - NC 80Ohm Analog Switches BREAK-BEFORE-MAKE 16 Pins 500pA 15V 16-SOIC (0.154, 3.90mm Width)
Package:
-
Production Status:
In Stock Status:
Specification
Package / Case
16-SOIC (0.154, 3.90mm Width)
Moisture Sensitivity Level (MSL)
Peak Reflow Temperature (Cel)
Time@Peak Reflow Temperature-Max (s)
Voltage - Supply, Single/Dual (±)
Neg Supply Voltage-Nom (Vsup)
On-State Resistance (Max)
Multiplexer/Demultiplexer Circuit
Current - Leakage (IS(off)) (Max)
Channel Capacitance (CS(off), CD(off))
Switch Time (Ton, Toff) (Max)
Products Detail
DG444BDY Overview
The electrical component comes in 16-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 16 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Circuits number 4 make up this analogue multiplexer. A 80Ohm internal resistance characterizes this multiplexer. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 13V as the lowest voltage for the electrical part. A voltage higher than 1μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 22VFor dual power supplies, a voltage of at least 7V should be attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer.
DG444BDY Features
1 Channels
Switch Circuit: SPST - NC
DG444BDY Applications
There are a lot of Vishay Siliconix
DG444BDY Analog Switches & Multiplexers ICs applications.
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
- Data Acquisition Systems
- Relay Replacement
- Battery Powered Systems
- Existing multiplexer applications (both fault-protected and nonfault-protected)
Key Features
No key features available
Application scenarios
No application scenarios available
Documents
