TS612IDT [STMicroelectronics]

TS612IDT Overview

Packaged in a SO case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 20. The pins on this board total to 20 in total. I would like to remind you that this buffer op amp should be powered by an 6V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. There is an input offset voltage of 6mV for this buffer op amp. Keeping the voltage gain at 80.83dB is the best course of action. As far as the device is concerned, buffer amplifier has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 85°C should be used. The operating supply voltage of the buffer op amp is rated at 6V. For packing the buffer amplifier, the TAPE AND REEL-axis is adopted. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 6V volts.

TS612IDT Features

20 Pins
supply voltage of 6V
80.83dB voltage gain

TS612IDT Applications

There are a lot of STMicroelectronics
TS612IDT Instrumentational OP Amps applications.

• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement
• Power control
• Information processing
• Weak signal detection