LM258AYD [STMicroelectronics]

LM258AYD Overview

The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Rail/Tube case is used for delivering the op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 5V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 8 pins on it. Op amp rates 3mV as input offset voltage. You should keep the voltage gain at 100dB for the time being. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 105°C should not be used for the operation of buffer amplifier. 2 elements make up the design of this buffer amplifier. This electric component can work from a voltage of under 30V as far as supply voltage is concerned. A voltage of 3V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 15V volts when you conduct this part.

LM258AYD Features

8 Pins
supply voltage of 5V
100dB voltage gain

LM258AYD Applications

There are a lot of STMicroelectronics
LM258AYD Instrumentational OP Amps applications.

• Multiplication circuits
• Division circuits
• Precision measurement
• Power control
• Information processing
• Weak signal detection
• Signal amplification
• Signal filtering
• Signal operation
• Video computer boards